abrasiveness

英

美

n.  磨耗；磨损性；磨蚀（性）；研磨；耐磨性

化学

COCA.40982

英英释义

noun

• the quality of being sharply disagreeable
• the roughness of a substance that causes abrasions
  Synonym:harshnessscratchiness

双语例句

• Effect of Nanometer Rare-earth La_2O_3 on Structure and Abrasiveness of Ni-based Alloy Spray-welding Coating
  纳米稀土La2O3对Ni基合金喷焊层组织和耐磨性的影响
• Through abrasion resistant bead welding of bucket teeth and shovel bucket, their surface hardness and abrasiveness as well as the toughness of the matrix were improved, therefore, the service life was increased.
  通过对斗齿、挖斗进行耐磨堆焊，提高了其表面硬度和耐磨性，使基体具有高的韧性，大大提高了使用寿命。
• The structure, property and impact abrasiveness mechanism of a low alloy ductile iron have been studied.
  研究了低合金球墨铸铁经热处理后的组织、性能与冲击磨损机理。
• In order to understand the abrasiveness of coal to mining machinery and its mechanism, abrasive wear tests have been made in a modified M-200 tester with steel of different carbon contents, using mining run coal, float coal and coal with different quartz contents as abrasives.
  为了搞清煤对矿山机器的磨损作用及磨损机制，用不同碳含量的钢在改装的M-200磨损试验机上进行了原煤、浮选煤和煤中加不同石英砂含量的三体磨料磨损试验。
• But in this experiment, graphite content can not explain its abrasiveness high, can be good.
  但在本实验中，石墨含量高并不能说明其磨损性能就好。
• The results show that different heat treatment systems can really influence the abrasiveness of the composite.
  结果表明：不同的热处理制度确实能够影响材料的耐磨性。
• The effects of different granularity proportion and volume fraction of WC grains as wear resistant phase on microstructure and abrasiveness of composite alloy were studied by experiment. The research results were then applied to wear resisting supporting roller and disc pad used in middle speed coal crusher.
  试验研究了耐磨相WC颗粒的不同粒度配比和体积分数对复合合金组织及耐磨性的影响，并将研究结果应用于中速磨煤机耐磨辊胎和盘瓦。
• The results obtained from abrasiveness measurement of rocks by using the wearing capacity of a copper needle are described in this paper.
  本文阐述了用钢针磨损法测定岩石研磨性的试验结果。
• The research purpose of this paper is improvement copper-based powder metallurgical pantograph sliding plate deliver the performances such as density, electrical conductivity and surface hardness, and eventually improve its abrasiveness can.
  本论文的研究目的是改善铜基粉末冶金受电弓滑板的致密度、电导率、表面硬度等性能，并最终改善它的磨损性能。
• According to the summary of the methods to evaluate the formation drilling resistance, the rock drillability and abrasiveness were selected to be the standards.
  总结目前地层抗钻特性评价方法，选取岩石可钻性级值和岩石研磨性作为评价标准。