capacitances
英 [kəˈpæsɪtənsɪz]
美 [kəˈpæsətənsɪz]
n. 电容，电容量(系统贮存电荷的能力); 电容率(电荷和电位变化之比值)
capacitance的复数
双语例句
- Simulative results show that, the dominant time constants can diagnose the insulation conditions of transformers with different geometric capacitances, which is an effective characteristic variable.
仿真分析结果表明，回复电压特征量的主时间常数能诊断不同几何电容的变压器的绝缘状态，是一个诊断绝缘状态的有效特征量； - For three-phase three-wire systems two control strategies are researched, strategies based on load current detection and on DC capacitances 'voltage detection.
对于三相三线制系统的两种控制策略进行了研究：基于检测负载电流和基于检测直流侧电容电压的控制策略。 - The grounding current EMI is caused by charging and discharging of the parasitic capacitances between the circuit and ground during the switching instant devices.
地电流干扰主要是由于半导体器件开关动作产生的快速上升和下降的开关电压作用在对地电容上产生的位移电流形成的。 - High-speed interfaces require TVSs with particularly low shunt capacitances.
高速接口需要带特殊低旁路电容的TVS。 - In design of variable oscillator, programmable logic device, resistances and capacitances are put together to form a funcitional block.
利用可编程逻辑器件和阻容元件构成一个变音振荡器，实现了可编程逻辑器件和模拟电路的有机结合。 - The parasitical capacitances of power devices greatly influence the power dissipation and performance of driver ICs for flat panel display.
功率器件寄生电容的大小直接关系到平板显示器驱动芯片的功耗及性能。 - The analytic results indicate that the reasonable interface circuit can substantially remove the impacts of these parasitic capacitances, reduce the attenuation of signal, restrain the noise signal and coupling signal.
结果表明，合理的接口电路不仅消除了大部分的寄生电容的影响，而且减小了信号的衰减幅度，抑制了大部分的耦合信号和噪声信号。 - This paper presents a new time-efficient method for the estimation of crosstalk, which considers the effect of coupling capacitances and inductors completely.
在充分考虑互连线的电容耦合效应和电感耦合效应的前提下，提出了一种有效估算互连串扰噪声的方法。 - The chaotic signal spectrum can be regulated by adjusting integral resistors or capacitances, convenient for practical applications.
可根据需要，通过调节积分电阻或积分电容的大小来改变混沌信号的频谱分布范围，便于实际应用。 - The calculated self-excited capacitances for various terminal voltages are in good agreement with experimental values.
论文给出了空载时建立不同数值端电压所需的电容值，计算结果与实验结果的相互吻合说明了分析方法的正确性。